Universal Multishot Systems UMS-45H
Year: 2009
Machine ID: 11193
Tonnage = 0, Shot Size = 13.65oz (24.65 in3)
→ In Stock ←
Universal Multishot Systems
Universal Multishot Systems UMS-HT75
Year: 2004
Machine ID: 11727
Tonnage = 0, Shot Size = .57 ounces
→ In Stock ←
How Universal Multishot Systems Support Your Production Needs
Precise Shot Sequencing
Maintain accurate shot order and timing when part quality depends on strict separation between materials or layers.
Managed Multi-Material Flow
The system accommodates pressure and temperature differences, so interfaces form cleanly without ongoing manual adjustment.
Output That Holds Over Time
Mechanical alignment and shot transfer accuracy help your parts meet the same quality standards at the end of a run as at the start.
Layout That Follows Your Tooling
Supports for rotary, transfer, and index-based setups allow you to select a configuration that fits your mold design rather than redesigning tooling around the press.
Key Features To Consider
Shot Volume Balance
The Universal Multishot injection molding system delivers consistent volume across injections, keeping material distribution predictable and part interfaces clean from cycle to cycle.
Indexing Accuracy
Rotary or transfer movement holds alignment during operation, reducing flash, mismatch, and interface defects across long runs.
Material Changeover Control
Independent temperature and pressure control between shots enables the processing of different materials without cross-contamination or variation in bonding.
Automation Synchronization
Timing between the press, transfer mechanisms, and handling equipment stays coordinated, allowing robots or pick-and-place units to integrate without disrupting the multishot sequence.
Why Manufacturers Work With Hunter Plastics on Universal Multi-shot Systems
Experience Beyond Single-Shot Evaluation
We evaluate Universal multishot machines based on live cycle behavior, not just basic press inspections.
System Selection Built Around Your Part Design
Machine options are shortlisted to match your part design and material requirements, not a generic configuration.
Faster Entry Into Multishot Production
Using multishot systems help you start production sooner without compromising process control.
Smarter Investment For Smaller Teams
We guide teams toward multishot capability that fits their operation without forcing major tooling or workflow changes.
FAQs
Is buying a used multishot injection molding machine riskier than buying a new one?
It depends on how the system is evaluated. Risk comes from unseen timing, transfer, or bonding issues, not age, so performance under a live multishot cycle matters more than build year.
What usually goes wrong in used multishot injection molding machines?
Most issues show up as shot-sequence drift, transfer-alignment wear, or inconsistent bonding between materials, especially if the system was not evaluated under load.
How do I know if a multishot system will work with my part design?
You need to confirm that the system’s shot order, transfer method, and material handling align with your part geometry and material stack, not just its tonnage rating.
Can a used multishot injection molding machine integrate with existing automation?
Yes, if the press, transfer mechanism, and controller can stay synchronized with your robots or handling equipment during the full multishot sequence.
Is a multishot system overkill if I only run limited two-shot production?
It can be, unless your part requires strict material separation or bonding consistency; those requirements justify multishot capability even at lower volumes.